2 SETUP 6
L01500-10
–
Mount reflector
with spring washers
on holding plate
.
–
Mount holding plate
on license plate bracket
.
(EU/AU/FR)
–
Mount license plate bracket
on license plate holder
.
(US/CN)
– Bond the reflectors on the right and left side of the reflector holder.
–
Mount the reflector holder and license plate bracket
on license plate
holder
.
L01507-01
(EU/AU/FR)
– Remove the passenger seat. ( p. 7)
– Secure the tool set with the rubber holder.
L01505-01
– Carefully loosen and remove the tension belt from the frame.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tension belts around the fork legs.
The vehicle is released at the front.
– Together with an assistant, take the vehicle off the palette.
– Remove the radiator shield.
L01508-10
– Remove the front rider's seat. ( p. 7)
–
Remove screw
.
–
Lift cover
at the rear and pull toward the rear.
– Fold up the cover.
–
Plug in the connector of starter relay
.
– Recharge the battery. ( p. 9)
– Remove the protective plastic.
– Refuel. ( p. 10)
– Prepare the vehicle according to the specifications in the KTM Dealer.net for han-
dover to the customer.
To Next Page
Loading...
