3 WORK 8
602678-01
– Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the open-circuit voltage and start
potential of the battery, and to test the alternator. With this device, you cannot
overcharge the battery.
Info
Charge the battery with a maximum of 10% of the capacity specified on the
battery housing.
– Switch off and disconnect the battery charger from the battery after charging.
Guideline
The charging current, charging voltage, and charging time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
L01483-12
–
Mount positive terminal cover
.
–
Position negative cable
and mount and tighten the screw.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
L01486-11
–
Position cover
.
Screw heads
engage in recesses
.
–
Mount and tighten screw
.
Finishing work
– Mount the front rider's seat. ( p. 6)
– Mount the passenger seat. ( p. 6)
– Set the time and date.
To Next Page
Loading...
Need help?
General
