ENGLISH
15
WARNING
ALL MAINTENANCE AND ADJUSTEMENT OPERATIONS THAT ARE MARKED WITH A
*
REQUIRE SPECIALIST KNO-
WLEDGE. FOR YOUR OWN Safety, LET THESE TASKS BE CARRIED OUT BY A KTM-DEALER
!
CAUTION
!
–W
HEN CLEANING THE MOTORCYCLE, DO NOT USE A HIGH PRESSURE CLEANING UNIT IF POSSIBLE, OTHERWISE WATER WILL PENETRATE THE BEARINGS,
CARBURETOR, ELECTRIC CONNECTORS ETC
.
–WHEN TRANSPORTING YOUR
KTM, ENSURE THAT IT IS HELD UPRIGHT WITH RESTRAINING STRAPS OR OTHER MECHANICAL FASTENING DEVICES
. IFTHE
MOTORCYCLE SHOULD FALL OVER
, FUEL CAN LEAK FROM THE CARBURETOR OR FUEL TANK
–DO NOT USE TOOTHED WASHERS OR SPRING WASHERS WITH THE ENGINE FASTENING SCREWS
, AS THESE WORK INTO THE FRAME PARTS AND KEEP WOR-
KING LOOSE. INSTEAD,
USE SELF-LOCKING NUTS
.
–L
ET YOUR MOTORCYCLE COOL DOWN BEFORE BEGINNING ANY MAINTENANCE WORK IN ORDER TO AVOID GETTING BURNED.
–D
ISPOSE OF OIL
, GREASE, FILTERS,
FUELS, CLEANING AGENTS ETC. ACCORDING TO YOUR LOCAL REGULATIONS.
–U
NDER NO CIRCUMSTANCES MAY USED OIL BE DISPOSED OF IN THE SEWAGE SYSTEM OR IN THE OPEN COUNTRYSIDE. 1 LITER USED OIL CONTAMINATES
1.000.000 LITERS WATER.
Tool set
The tool set 1 is located in the tool box under the right side cover.
Removing the seat
Remove the collar screws 2 from the underside of the fender. Lift the rear
of the seat, pull backwards, and unhook it from the oval-head screw
3.
To install the seat, hook the seat into the oval-head screw, set the rear por-
tion down on the frame, and slide it forward. If necessary, press down on
the front area of the seat so that the seat catches on the retaining bracket
4. Insert and tighten the collar screw.
MAINTENANCE WORK ON CHASSIS AND ENGINE
1
2
2
3
4
To Next Page
Loading...
Need help?
General
