ENGLISH
29
Changing oil filter *
Replace the oil filter when changing the engine oil. Press the foot brake
pedal and place a screwdriver or similar between foot brake pedal and
stopper roll so that the oil filter cover is more accessible. Remove banjo bolt
1
and the three screws. Remove oil filter cover
2
and oil filter. Clean fil-
ter housing, oil filter cover, and sealing surfaces. Check oil duct in oil filter
cover if clogged.
Check the O-ring
3
for damage. O-rings need not be replaced unless
damaged. Press the O-ring into the groove of the filter cover. Fit new oil
filter
4
with rubber gasket on the fitting in oil filter cover and mount cover
with filter. Mount three screws and tighten with 5 Nm (4 ft.lb). Mount hol-
low screw with seal rings and tighten with 15 Nm (11 ft.lb). Start engine
and check oil system for leakage.
1
2
3
4
1
2
To Next Page
Loading...
Need help?
General
