To Next Page

To Previous Page

24 STANDARDS 130

JASO T903 MA

Different technical development directions required a new specification for 4-stroke motorcycles – the JASO T903 MA Standard. Ear-

lier, engine oils from the automobile industry were used for 4-stroke motorcycles because there was no separate motorcycle specifi-

cation. Whereas long service intervals are demanded for automobile engines, high performance at high engine speeds are in the fore-

ground for motorcycle engines. In most motorcycles, the gearbox and the clutch are lubricated with the same oil as the engine. The

JASO MA Standard meets these special requirements.

SAE

The SAE viscosity classes were defined by the Society of Automotive Engineers and are used for classifying oils according to their vis-

cosity. The viscosity describes only one property of oil and says nothing about quality.

JASO FD

JASO FD is a classification for a 2-stroke engine oil that was specifically developed for the extreme demands of racing. Thanks to first

rate synthetic esters and specially designed additives, superb combustion is achieved even under extreme operating conditions.

KTM 250 XC 2017 Specifications

General

KTM 250 XC 2017 User Manual

Other manuals for KTM 250 XC 2017