Why are the speedometer, horn, brake light, turn signal, and radiator fan not working on my KTM 500 EXC US Motorcycle?
If the speedometer, horn, brake light, turn signal, and radiator fan are not working on your KTM Motorcycle, it is likely due to a blown fuse 4. Replace the fuses of individual power consumers.
General| Bore x Stroke | 95 mm x 72 mm |
|---|---|
| Transmission | 6-speed |
| Seat Height | 960 mm |
| ABS | No |
| Ground Clearance | 355 mm |
| Starter | Electric starter |
| Engine Type | 1-cylinder, 4-stroke engine |
| Power | Not available |
| Torque | Not available |
| Rear Suspension | WP Xplor PDS |
| Front Brake | 260 mm disc |
| Rear Brake | 220 mm disc |
| Fuel System | Keihin EFI |
Explains the meaning of specific symbols used in the manual.
Explains the typographical formats used within the document.
Defines the intended use and operating parameters for the motorcycle.
Details risk levels and associated warning symbols for safety.
Illustrates and describes various warning and information labels on the vehicle.
Instructions on how to report vehicle defects that could cause accidents.
Provides guidance on safe operating practices and considerations.
Emphasizes the importance and necessity of wearing protective gear.
Outlines conditions and procedures for guarantee and warranty claims.
Specifies required operating fluids and their safe handling.
Highlights the importance of proper service for performance and longevity.
Identifies key components of the vehicle from the front left perspective.
Identifies key components of the vehicle from the rear right perspective.
Location and identification of the vehicle's chassis number.
Location and identification of the vehicle's engine number.
Information on locating the key number for replacement key orders.
Description and function of the clutch lever.
Description and function of the front brake hand lever.
Operation of the light switch for different beam settings.
Function and positions of the emergency OFF switch.
Location and operation of the ignition lock for starting the vehicle.
Instructions on how to open and close the fuel tank filler cap.
Location and function of the steering lock mechanism.
General overview of the speedometer display and buttons.
How to change the unit of measurement for distance.
Procedure for setting the current time on the speedometer.
Explains the display mode for engine service hours.
Changing the unit of measurement (e.g., Km/h or Mph).
Essential safety and operational advice for initial use of the vehicle.
Guidelines for the engine's break-in period to ensure longevity.
Steps for preparing the vehicle for various challenging terrains and conditions.
Pre-ride checks and maintenance tasks for safe operation.
Procedures for safely starting the motorcycle's engine.
How to shift gears and maintain stable riding.
Techniques and precautions for effective braking.
Instructions and safety precautions for refueling the fuel tank.
Lists maintenance tasks and their recommended intervals for optimal performance.
How to adjust suspension based on rider weight for optimal handling.
Explanation of compression and rebound damping adjustments.
Procedures to adjust fork damping and spring preload.
Procedure for adjusting the handlebar position.
Step-by-step guide to removing and installing the front fork legs.
How to check and adjust steering head bearing play.
Steps to remove and install the rear shock absorber.
Procedures for cleaning and maintaining the air filter.
How to check and adjust drive chain tension and condition.
Steps to remove and install the motorcycle's fuel tank.
How to check and adjust free play in brake levers.
How to check and replace brake linings.
How to check and replenish brake fluid levels.
Step-by-step guides for front and rear wheel removal/installation.
How to inspect tire condition and adjust air pressure.
Method for checking and adjusting spoke tension for wheel balance.
Procedures for battery care, including removal, installation, and charging.
How to locate and replace main and individual fuses.
Procedures for replacing headlight and turn signal bulbs.
How to check and adjust the headlight beam alignment.
Procedure for replacing the battery in the speedometer unit.
How to check coolant level and antifreeze protection.
Steps to safely drain and refill the cooling system.
How to check and adjust throttle cable play for proper response.
How to set the engine's idle speed.
Steps to replace the fuel filter screen.
How to check the engine oil level.
Procedure for changing engine oil, filter, and cleaning oil screens.
Guidelines for washing and cleaning the motorcycle.
Maintenance procedures for protecting the vehicle during winter storage.
Steps for preparing the motorcycle for long-term storage.
Procedures for bringing the motorcycle back into service after storage.
Diagnosing and resolving engine starting problems.
Troubleshooting engine power and acceleration issues.
Diagnosing engine overheating and interpreting warning lamps.
Troubleshooting battery and general electrical system problems.
Explains the meaning of various blink codes from the FI warning lamp.
Details on engine specs, including tightening torques.
Details on chassis components, including tightening torques.
Specifications for electrical system and tire sizes.
Technical details for fork and shock absorber settings.
Details on approved brake fluid, coolant, and oil types.
List of recommended cleaners, lubricants, and additives.
Explanation of JASO and SAE standards for motorcycle oils.
Definitions of common abbreviations used in the manual.
Meanings of yellow, orange, green, and blue symbols.
To Next Page