WORK 3
13
Info
The vehicle has been set up in the factory for one-
person operation. Only an authorized KTM workshop
may carry out the conversion.
The components for one-person operation and for oper-
ation with a passenger are included in the scope of
supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
3.3 Mounting the passenger seat
K01360-10
–
Hook holding lugs
1
of the passenger seat onto the storage
compartment, lower the rear and push forward.
– Press the passenger seat downward until it clicks into place.
Warning
Danger of accidents The seat can come loose from the
anchoring if it is not mounted correctly.
– After assembly, check whether the seat is correctly
locked and cannot be pulled up.
– Finally, check that the passenger seat is correctly mounted.
Info
The vehicle has been set up in the factory for one-
person operation. Only an authorized KTM workshop
may carry out the conversion.
The components for one-person operation and for oper-
ation with a passenger are included in the scope of
supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
3.4 Charging the 12-V battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
–
Keep sparks or open flames away from the 12 V battery.
– Only charge 12 V batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Note
Danger of damage An incorrectly selected charging mode will damage the 12-V battery.
– Always select a charging mode that is compatible with the type of battery.
To Next Page
Loading...
