KTM 890 DUKE R 2022 User Manual

SETUP 2
3
2.1 Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Diagnostics connector
H02681-10
Diagnostics connector
1
is located under the passenger seat.
2.3 Unpacking and setting up the vehicle
V01334-10
– Remove the straps and the box.
V01335-01
– Remove the adhesive tape in the upper area of the motorcycle.
– Roll down the film at the sides.
Guideline
To avoid damaging the vehicle while setting it up, do
not remove the protective film on each component until
installing the component, and leave it on the vehicle until
work has been completed.
– Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
Info
The procedure for missing components is described in
the Customer Service Manual.
– Check the vehicle for transport damage.

KTM 890 DUKE R 2022 Specifications

General

Engine Type	2-cylinder, 4-stroke, parallel twin
Displacement	889 cm³
Transmission	6-speed
Cooling	Liquid cooled
Seat Height	834 mm
Weight (without fuel)	166 kg
Front Suspension	WP APEX 43
Front Tire	120/70 ZR 17
Rear Tire	180/55 ZR 17
Bore x Stroke	90.7 mm x 68.8 mm
Compression Ratio	13.5:1
Fuel System	Electronic Fuel Injection
Final Drive	Chain
Power	121 hp
Torque	99 Nm
Fuel Tank Capacity	14 liters
Rear Suspension	WP APEX
Rear Brake	240 mm disc, single-piston floating caliper
ABS	Bosch 9.1 MP (incl. Cornering-ABS and Supermoto mode)
Frame	Chromoly-steel trellis frame, powder coated
Front Brake	2 x Brembo Stylema four piston, radially mounted calipers
Wheelbase	1, 482 mm