Why have all the switched-on lamps blown out on my KTM Motorcycle?
If all the switched-on lamps have blown out on your KTM Motorcycle, remove the seat and check the connections. Have the voltage regulator checked. The cause is a faulty voltage regulator.
General| Engine Type | Single cylinder, 4-stroke |
|---|---|
| Displacement | 625 cc |
| Bore x Stroke | 101 mm x 78 mm |
| Cooling System | Liquid cooled |
| Compression Ratio | 11.7:1 |
| Transmission | 5-speed |
| Front Suspension | WP USD 48 mm |
| Rear Suspension | WP monoshock |
| Front Tire | 120/70 R17 |
| Rear Tire | 160/60 R17 |
| Seat Height | 910 mm |
| Power | 54 hp |
| Fuel System | Keihin FCR 41 |
| Ignition | Digital |
| Front Brake | Single disc, 320 mm |
| Rear Brake | Single disc, 220 mm |
Locates and describes the chassis number for identification.
Details on locating and identifying the engine number and type.
Explains the operation and adjustment of the clutch lever.
Describes the function and usage of the hand decompression lever.
Details on operating the choke lever for cold starts and its adjustment.
Explains the function and checks for the hand brake lever.
Description of the speedometer, odometer, and various indicator lamps.
Operation of the ignition lock with four distinct switch positions.
Operation of the ignition lock with three distinct switch positions.
Explains the functions of the combination switch for lights and horn.
Details on using the starter and emergency off switches for safety.
Instructions for opening and closing the fuel filler cap.
Specifies the type of gasoline required and cautions for its use.
Explains the operation of the fuel tap (OFF, ON, RES) and its importance.
Description of the shift lever and gear position indication.
Instructions and safety warnings for using the kickstarter.
Details on the foot brake pedal and its adjustment.
How to adjust the compression damping of the front fork.
How to adjust the rebound damping of the front fork.
How to adjust the compression damping of the rear shock absorber.
How to adjust the rebound damping of the rear shock absorber.
Describes the passenger holding bars on the rear of the vehicle.
Step-by-step guide for starting the engine when it is cold.
Procedure for starting the engine when it is warm or hot.
Procedure for starting the engine if it is flooded.
Detailed instructions and safety for using the kickstarter.
Steps and safety precautions for starting to ride the motorcycle.
Guidance on shifting gears and riding the motorcycle safely.
Instructions and safety advice for effective braking.
Procedure for safely stopping and parking the motorcycle.
Instructions and cautions for using the motorcycle's center stand.
Instructions and cautions for using the motorcycle's side stand.
Locates and describes the tool set for maintenance.
Step-by-step guide for removing and refitting the motorcycle seat.
Procedure for checking and adjusting the steering head bearing for play.
How to adjust the spring preload on the rear shock absorber.
Instructions for lubricating the shock absorber linkage.
Procedure for checking the rubber ring on the rear shock absorber for wear.
How to check and adjust the chain tension for proper operation.
Details on setting the correct chain tension and wheel alignment.
Guidance on maintaining the X-ring chain for longevity.
Method for checking chain wear and when to replace it.
General information on KTM disc brakes, calipers, pads, and fluid.
How to adjust the free travel on the hand brake lever.
Procedure for checking the brake fluid level in the front brake reservoir.
Instructions for refilling the front brake fluid reservoir.
How to inspect the thickness of the front brake pads.
Procedure for adjusting the basic position of the foot brake pedal.
Procedure for checking the brake fluid level in the rear brake reservoir.
Instructions for refilling the rear brake fluid reservoir.
How to inspect the thickness of the rear brake pads.
Detailed steps for removing and installing the front wheel on LC4 models.
Steps for removing and installing the front wheel on LC4 Supermoto.
Procedure for removing and installing the rear wheel on LC4 models.
Steps for removing and installing the rear wheel on LC4 Supermoto.
How to check the shock absorption rubbers in the rear wheel hub for wear.
Information on approved tires, types, and correct air pressure.
How to check and adjust spoke tension for wheel stability.
Details on battery removal, installation, and general care.
Procedure and guidelines for charging the motorcycle battery.
Locating and replacing the main fuse, with safety precautions.
Information on fuses for individual power-consuming units.
Step-by-step guide for replacing the headlight bulb.
Procedure for replacing the parking light bulb.
Instructions for replacing brake and tail light bulbs.
Explanation of the cooling system's function and potential overheating causes.
How to check the cooling liquid level when the engine is cold.
Procedure for cleaning the air filter for engine longevity.
How to adjust the engine's idle speed using the adjusting screw.
How to adjust the throttle cable for correct free play.
Procedure for draining the carburetor float chamber.
How to adjust the play in the clutch cable.
How to check and adjust the choke cable play.
Procedure for checking and adjusting the hand decompression cable.
Details on the recommended type and quality of engine oil.
Procedure for checking the engine oil level correctly.
Diagram and explanation of the motorcycle's oil circulation system.
Steps for changing engine oil, filters, and bleeding the oil system.
Procedure for replacing the engine oil filter.
Procedure for preparing the motorcycle after a period of storage.
Procedure for reporting safety defects to NHTSA and KTM.
Information regarding the warranty for the exhaust system's noise emissions.
Warning against tampering with the noise control system.
Statement regarding checks for repair or replacement if noise increases.
To Next Page