— 18 —
TROUBLESHOOTING
SYMPTOM: KS Clock paired with a Bluetooth device earlier today (or yesterday) but it does
not work anymore now.
SOLUTION(s): Enter Bluetooth list (in Setting’s menu of Bluetooth device) and delete any entry
named “KS CLOCK”. On Apple devices, this function may be executed by
selecting “Forget this device”. After erased, attempt to pair again; see Setting
the Time section.
KS clock may be programmed by the KS Programmer to periodically stop
pairing with recent devices. The period of time for this function is defined
by the “Clear Pairing List” function of the KS Programmer. When KS clock
executes this function, the Bluetooth user will need to manually pair again with
KS Clock in order to re-establish Bluetooth connection. In order to prevent KS
Clock from rejecting the reconnection, ensure that the Bluetooth name KS-
CLOCK is deleted from the device list before re-pairing.
The clear pairing list cycle time begins from the time when this function was
programmed into KS Clock by the KS programmer. The function is suspended
while a device is connected.
SYMPTOM: When playing music via the AUX Audio connection, pressing the Volume
button on top of KS Clock does not change the volume of the music.
SOLUTION(s): The volume buttons are only for Bluetooth music. Please use the volume on
your audio device to change the volume of music played on KS Clock.
SYMPTOM: The clock display is too bright.
SOLUTION(s): The brightness setting is set by the KS Programmer. Please see KS
Programmer instructions. There is a setting for daytime and a separate setting
for nighttime.
SYMPTOM: The clock display is too dim.
SOLUTION(s): Ensure that the right side of KS Clock has at least 1 inch of free area. There is
a small port hole on the right side where KS Clock has an ambient light sensor.
This sensor needs to be exposed to ambient room light so that when the room
is bright, the clock display will brighten up.
The brightness setting is set by the KS Programmer. Please see KS
Programmer instructions. There are separate settings for daytime and
nighttime.
SYMPTOM: KS Clock is configured for manual time setting and the displayed time is now
DST. Pressing DST- does not do anything and pressing DST+ causes the time
to advance even further by another hour.
SOLUTION(s): The time was incorrectly set by a previous setup. Press the Clock set button
and manually change the time one hour behind. After correct setup, pressing
DST+ should advance the time by one hour to summer time, and pressing
DST- will skip back the time by one hour to Winter time.
To Next Page
Loading...