Kubota B2301-1 Workshop Manual

GENERAL
B2301, B2601, WSM
G-29
Replacing Hydraulic Oil Filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plugs at the bottom of the transmission case
and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil filter.
4. Put a film of clean transmission oil on the rubber seal of the new
filter.
5. Quickly tighten the filter until it contacts the mounting surface,
then tighten it by hand an additional 1/2 turn only.
6. After the new filters have been replaced, fill the transmission oil
up to the upper notch on the dipstick.
7. After running the engine for a few minutes, stop the engine and
check the oil level again, add oil to the prescribed level.
8. Make sure that the transmission fluid does not leak past the seal
on the filter.
IMPORTANT
• To prevent serious damage to the hydraulic system, use
only a KUBOTA genuine filter.
9Y1211156GEG0038US0
Changing Front Axle Case Oil
1. Park the tractor on a firm, flat and level surface.
2. To drain the used oil, remove the right and left drain plugs and
filling plug at the front axle case and drain the oil completely into
the oil pan.
3. After draining, reinstall the drain plugs.
4. Fill with new oil up to the upper notch on the dipstick.
IMPORTANT
• After ten minutes, check the oil level again; add oil to
prescribed level.
5. After filling, reinstall the filling plug.
6. Properly dispose of used oil.
9Y1211156GEG0039US0
(1) Drain Plug
(2) Drain Plug (Both Sides)
(3) Transmission Oil Filter
(4) Oil Inlet
(5) Dipstick
A: Oil level is acceptable within this
range.
Oil capacity
3.5 L
3.7 U.S.qts
3.1 Imp.qts
(1) Filling Plug with Dipstick
(2) Drain Plug
A: Oil level is acceptable within this
range.
KiSC issued 11, 2014 A

Kubota B2301-1 Specifications

General

Brand	Kubota
Model	B2301-1
Category	Tractor
Language	English