Kubota B3350HSDC - Tire Pressure; Tires

GENERAL
B2650HSDC, B3350HSDC, WSM
G-56
9. TIRES
[1] TIRE PRESSURE
WARNING
To avoid personal injury:
• Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper
equipment.
• Always maintain the correct tire pressure. Do not inflate tires above the recommended pressure shown
in the operator's manual.
IMPORTANT
• Do not use tires other than those approved by KUBOTA.
9Y1210822GEG0081US0
Inflation Pressure
Through the tire pressure is factory-set to the prescribed level,
it naturally drops slowly in the course of time. Thus, check it every
day and inflate as necessary.
NOTE
• Maintain the maximum recommended pressure in the front
tires, when using a front loader or when equipped with a
full load of front weights.
 Dual Tires
• Dual tires are not approved.
9Y1210822GEG0082US0
Tire sizes Inflation pressure
Rear
12.4-16, 4PR 110 kPa (1.1 kgf/cm
2
, 16 psi)
13.6-16, 4PR 100 kPa (1.0 kgf/cm
2
, 14 psi)
12.4-16 Ind., 4PR 138 kPa (1.4 kgf/cm
2
, 20 psi)
Front
7-12, 4PR 170 kPa (1.7 kgf/cm
2
, 24 psi)
24 × 8.50-14, 4PR 150 kPa (1.5 kgf/cm
2
, 22 psi)
23 × 8.50-14 Ind., 4PR 241 kPa (2.5 kgf/cm
2
, 35 psi)
(A) Insufficient
(B) Standard
(C) Excessive
(D) Ground
KiSC issued 05, 2014 A