ENGINE
B2650HSDC, B3350HSDC, WSM
1-M16
(4) Regeneration Mode (Default Version)
DPF regeneration process can be performed by choosing from "Auto Regeneration" or "Regeneration inhibit"
mode according to your job conditions. For jobs not affected by hot gases emitted during regeneration, the "Auto
Regeneration" is advisable.
Auto Regeneration Mode
When starting the engine (switch operation is unnecessary), the "Auto Regeneration" mode is automatically
activated.
With the auto regeneration mode on, when a specific amount of PM has accumulated, and the regeneration
conditions are satisfied (See the "Tips on Diesel Particulate Filter [DPF] Regeneration"), the DPF will be automatically
regenerated whether the tractor is in motion or parked.
By this way, work efficiency is improved. For details of auto regeneration, refer to "Operating Procedure for Auto
Regeneration Mode" section.
Inhibit Mode
After starting the engine, if the "DPF INHIBIT switch" is pressed to turn on the switch lamp, the "Regeneration
inhibit" mode will be activated.
With "Regeneration Inhibit" mode on, the PM which has accumulated inside the DPF will not be burnt, unless the
operator performs the regeneration work manually.
The "Regeneration Inhibit" mode is effective for work in poorly ventilated work spaces.
For details of regeneration prohibition, refer to "Operating Procedure for Regeneration Inhibit Mode" section.
• If stop the engine once, the "Auto Regeneration " mode will be activated.
9Y1210822ENM0035US0
To Next Page
