Kubota EA330-E4 Series - Check Point of Every 50 Hours; Check Point of Every 100 Hours

GENERAL
EA330-E4, WSM
G-8
[2] CHECK POINT OF EVERY 50 HOURS
Checking Air Cleaner Element
IMPORTANT
• When used in a dustily place, check the cleaner every day,
and clean.
1. Ensure that the element (1) or the dust cup (2) is not clogged by
dirt or dust.
2. If necessary, clean them according to the procedure in the
following section "Cleaning Air Cleaner Element".
NOTE
• Do not let dust build up to move than half way up the dust
cap.
9Y1211018GEG0007US0
[3] CHECK POINT OF EVERY 100 HOURS
Changing Engine Oil and Cleaning Oil Strainer (First 50 Hours
and Every 100 Hours)
1. After warming up the engine, remove the drain plug (1) and
drain the oil completely.
2. Clean the inside of the oil strainer and the cylinder block withe
gas oil.
3. Supply the specified quantity of the specified oil through the oil
inlet.
IMPORTANT
• Engine oil should have properties of API classification CF.
• Change the type of engine oil according to the ambient
temperature.
9Y1211018GEG0008US0
Cleaning of Air Cleaner Element
1. Remove the air cleaner element.
2. Use clean dry compressed air on the inner side of the element.
The pressure of compressed air must be less than 205 kPa
(2.1 kgf/cm
2
, 30 psi).
Keep an appropriate distance between the nozzle and the filter.
NOTE
• The air cleaner uses a dry element. Do not apply oil to it.
• Do not operate the engine without the filter element.
• Replace the element once a year or every sixth cleaning.
9Y1211018GEG0009US0
(1) Air Cleaner Element (2) Dust Cap
Engine oil quantity
1.3 L
0.34 U.S.gals
Above 20 °C (68 °F) SAE30
5 to 20 °C (41 to 68 °F) SAE20
Below 5 °C (41 °F) SAE10W or SAE10W-30
(1) Drain Plug (Oil Strainer)
KiSC issued 05, 2015 A