ENGINE
EA330-E4, WSM
1-S24
Fuel Tank and Filter
1. Close the fuel valve (7) as shown in the photograph.
2. Remove the engine hook (1) and radiator cover (2).
3. Disconnect the overflow hose (3).
4. Remove the eye joint bolt of the injection pump to detach the
fuel hose 2 (4).
5. Remove the fuel filter mounting screw (8).
6. Remove the fuel tank (5), fuel filter and hose as an unit.
7. Remove the radiator net (6).
(When reassembling)
• Lap the overflow hose (3) below the radiator cover (2) as shown
in the photograph.
• Set the hose clamps securely.
9Y1211018ENS0026US0
Wire Harness
1. Disconnect the fan leads (1).
(When reassembling)
• The lead wire must be grounded at particular locations as
illustrated.
9Y1211018ENS0027US0
Fan Cover and Starter
1. Disconnect the glow plug cord (4).
2. Remove the flywheel cover (2).
3. Remove the fan cover (3).
4. Remove the starter (1), wire harness and battery cable as an
unit.
9Y1211018ENS0028US0
Cooling Fan
1. Remove the tension pulley (2).
2. Remove the cooling fan assembly (1).
(When reassembling)
• Adjust the fan belt tension to the factory specifications.
9Y1211018ENS0029US0
Tightening torque
Injection pump eye joint
bolt
25 to 29 N·m
2.5 to 3.0 kgf·m
18 to 21 lbf·ft
(1) Engine Hook
(2) Radiator Cover
(3) Overflow Hose
(4) Fuel Hose 2
(5) Fuel Tank
(6) Radiator Net
(7) Fuel Valve
(8) Fuel Filter Mounting Screw
Tightening torque Glow plug terminal nut
0.98 to 1.7 N·m
0.10 to 0.18 kgf·m
0.73 to 1.3 lbf·ft
(1) Fan Lead
(1) Starter
(2) Flywheel Cover
(3) Fan Cover
(4) Glow Plug Cord
(1) Cooling Fan Assembly (2) Tension Pulley
To Next Page
Loading...
