Kubota G26-2 User Manual (English)

Other manuals for Kubota G26-2

Questions and Answers:

J
Justin ScottSep 4, 2025
What to do if the discharge chute is plugged on my Kubota G26-2?
- D
  Douglas DickersonSep 4, 2025
  If the discharge chute on your Kubota Lawn Mower is plugged, it could be because the grass is too wet, so wait for it to dry. The grass might also be too long, so cut it to a manageable length. Cutting too low can also cause this, so adjust the cutting height. The engine rpm might be too low, so increase it, or the ground speed might be too fast, so reduce it. Finally, there might be restricted airflow, so clear any restrictions.
K
kathleenhodgeAug 25, 2025
What to do if Kubota Lawn Mower starter does not run?
- A
  alexandraingramAug 26, 2025
  If the Kubota Lawn Mower's starter doesn't run, the battery might be discharged, so try charging it. The starter or main switch could also be malfunctioning, requiring repair or replacement. Check the safety switches for proper adjustment or damage, and adjust or replace them if necessary. Ensure that all wiring and the ground cable are properly connected. If any are disconnected, connect them.
R
Ronald WilsonAug 26, 2025
Why Kubota Lawn Mower emits black or dark gray exhaust gas?
- S
  Suzanne WintersAug 27, 2025
  If the Kubota Lawn Mower emits black or dark gray exhaust gas, it could be due to several reasons. It might be overloaded, so reduce the load. Using low-grade fuel can also cause this issue, so switch to the specified fuel. Additionally, a clogged fuel filter or air cleaner could be the culprit; replace or clean them accordingly. Finally, deficient nozzle injection can lead to this problem, requiring repair or replacement of the nozzle.
K
Karen JohnsonAug 27, 2025
Why Kubota G26-2 engine revolution is not smooth?
- G
  Gabrielle MartinezAug 27, 2025
  If your Kubota Lawn Mower's engine revolution isn't smooth, several factors could be responsible. A clogged or dirty fuel filter is a common cause, so try replacing it. Similarly, a clogged air cleaner can lead to rough engine performance, so clean or replace it. Other potential issues include a fuel leak due to a loose injection pipe retaining nut, which you should tighten. A malfunctioning injection pump, incorrect nozzle injection pressure, or a stuck/clogged injection nozzle can also cause this, requiring replacement, adjustment, or repair/replacement, respectively. Lastly, a malfunctioning governor could be the reason, and it should be repaired.
E
Erica MorrisAug 28, 2025
Why is my Kubota G26-2 engine overheating?
- L
  leroyparkAug 28, 2025
  If the Kubota Lawn Mower engine is overheating, there are several potential causes. First, check the engine oil and coolant levels and fill if insufficient. Inspect the fan belt for breakage or elongation, and replace or adjust it as needed. The radiator net and fins could be clogged with dust, so clean them. Corrosion inside the radiator or coolant flow route can also cause overheating, requiring cleaning or replacement. A damaged radiator cap should be replaced. Avoid overload running by reducing the load. Other possible causes include a damaged head gasket, incorrect injection timing, or unsuitable fuel, requiring replacement, adjustment, or using the specified fuel, respectively.
A
Amanda JohnsonAug 29, 2025
What causes white or blue exhaust gas from Kubota Lawn Mower?
- B
  Blake HolmesAug 29, 2025
  If your Kubota Lawn Mower is producing white or blue exhaust gas, it could be due to excessive engine oil; reduce it to the specified level. Worn or stuck piston rings and cylinders can also cause this issue, so repair or replace them. Incorrect injection timing may be the culprit, so adjust it. Finally, check for deficient compression.
J
Jennifer ChaneySep 9, 2025
Why are the grass tips jagged and grayish brown after cutting with my Kubota G26-2?
- M
  Michael MccoySep 9, 2025
  If the grass tips are jagged and turn grayish brown after cutting with your Kubota Lawn Mower, the blades may be dull, so sharpen them, or worn, so replace them. It's also possible that the mower deck is not level, so level it.
C
Catherine ClementsSep 10, 2025
What to do if the discharge duct is plugged on my Kubota G26-2?
- B
  Brian CruzSep 10, 2025
  If the discharge duct is plugged on your Kubota Lawn Mower, it might be because the grass is too wet, so wait for it to dry. The grass could also be too long, so cut it to a manageable length. It could also be that the cutting height is too low, so adjust it. The engine rpm might be low, so increase it, or the ground speed is too fast, so reduce it. The grass container might be full, so empty it, or the grass container net might be clogged, so clean it.
J
Jonathon MartinezSep 3, 2025
Why is my Kubota G26-2 Lawn Mower leaving an uneven cut?
- H
  Harold HallSep 3, 2025
  An uneven cut from your Kubota Lawn Mower can result from several factors: The mower deck might not be level, so level the mower deck. The ground speed may be too fast, so reduce it. The blades could be dull, so sharpen them, or worn, so replace them. Tire inflation could also be a factor, so check and adjust it. Finally, the mower rollers might not be adjusted correctly, so adjust them.
D
Daniel CummingsSep 1, 2025
What to do if my Kubota Lawn Mower engine overheats?
- V
  vrandallSep 1, 2025
  If your Kubota Lawn Mower engine is overheating, check the coolant level and refill if low. Inspect the fan belt for looseness or defects, repairing or replacing as necessary. Also, the coolant flow route may be corroded, requiring cleaning or repair.

Kubota G26-2 Specifications

General

Engine Type	Diesel
Cylinders	3
Transmission	Hydrostatic
Power steering	Yes
Mower deck	Mid-mount
Number of blades	3
Deck Lift	Hydraulic
Gross Power	26 hp
Fuel Type	Diesel
Engine	Kubota D1105
Cooling	Liquid
Drive	4WD
Cutting Width	72 inches