101TIRES, WHEELS AND BALLAST
TIRES, WHEELS AND BALLAST
TIRES
To avoid personal injury or death:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the operator's manual.
A Do not use tires other than those approved by
KUBOTA.
A When optional different-diameter tires are fitted on the
machine, the travel speed display mode must be
changed. Otherwise the travel speed will not get
correctly displayed. Such mode switching is also
needed when the original tires are back on the
machine.
(See "SIDE DIGITAL DISPLAY" in "OPERATING THE
TRACTOR" section.)
BInflation Pressure
Though the tire pressure is factory-set to the prescribed
level, it naturally drops slowly in the course of time. Thus,
check it everyday and inflate as necessary.
A Maintain the maximum pressure in front tires, if using
a front loader or when equipped with a full load of front
weights.
[M100GX-II, M110GX-II]
[M128GX-II, M135GX-II]
BDual Tires
Dual tires are not approved.
Tire sizes Inflation Pressure
Front
340/85R24 160 kPa (1.6 kgf/cm )
380/70R24 160 kPa (1.6 kgf/cm )
360/80R24 160 kPa (1.6 kgf/cm )
380/70R20 160 kPa (1.6 kgf/cm )
360/70R20 160 kPa (1.6 kgf/cm )
8.3R32 240 kPa (2.4 kgf/cm )
280/85R28 140 kPa (1.4 kgf/cm )
360/70R24 160 kPa (1.6 kgf/cm )
Rear
460/85R34 140 kPa (1.4 kgf/cm )
520/70R34 160 kPa (1.6 kgf/cm )
480/80R34 160 kPa (1.6 kgf/cm )
540/65R30 240 kPa (2.4 kgf/cm )
540/65R28 240 kPa (2.4 kgf/cm )
270/95R44 240 kPa (2.4 kgf/cm )
300/95R42 160 kPa (1.6 kgf/cm )
380/80R38 240 kPa (2.4 kgf/cm )
Tire sizes Inflation Pressure
Front
14.9R24 160 kPa (1.6 kgf/cm )
420/70R24 160 kPa (1.6 kgf/cm )
400/80R24 320 kPa (3.2 kgf/cm )
230/95R32 320 kPa (3.2 kgf/cm )
320/85R28 160 kPa (1.6 kgf/cm )
Rear
18.4R38 160 kPa (1.6 kgf/cm )
520/70R38 160 kPa (1.6 kgf/cm )
480/80R38 320 kPa (3.2 kgf/cm )
270/95R48 320 kPa (3.2 kgf/cm )
320/90R46 320 kPa (3.2 kgf/cm )
To Next Page
Loading...
