PERIODIC SERVICE146
6. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
7. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak pass
the seal on the filter.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
EVERY 600 HOURS
BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
BAdjusting King-pin Pivot
Loosen the lock nut and tighten the adjusting screw with
following torque:
(1) Dipstick (A) Oil level is acceptable within this range
(1) Adjusting screw
(2) Lock nut
Adjusting screw 4.9 to 9.8 N-m, 0.5 to 1.0 kgf-m
Lock nut 98.1 to 147 N-m, 10 to 15 kgf-m
(1) Adjusting screw
(2) Lock nut
To Next Page
Loading...
