75PTO
BPTO Gear Shift Lever
To avoid personal injury or death:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
540E rpm positions.
Move this lever to either position with the PTO clutch
control switch set to "OFF".
A For maximum PTO shaft speeds of various
implements, see the implement Operator's Manual.
A Whenever the PTO speed is changed to the other
speed, it is necessary to switch the PTO speed display
mode of the side digital display. Otherwise the PTO
speed will not get correctly displayed in the side digital
display. (See "SIDE DIGITAL DISPLAY" in
"OPERATING THE TRACTOR" section.)
B1000 rpm PTO Shaft
To avoid personal injury or death:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
By interchanging the PTO shafts, two different PTO shaft
speeds can be obtained.
C PTO shaft interchanging procedure
1. The 6-spline 540 rpm PTO shaft is standard
equipment.
2. Place an oil pan under the PTO shaft to catch oil
spillage. Remove the snap ring, and then the PTO
shaft.
3. Install the 21-spline PTO shaft (1000 rpm). To ensure
that it is tight, push it in by turning.
4. Reinsert the snap ring.
5. Set the distance from drawbar pin hole to the rear end
of PTO shaft according to the following instructions.
A For maximum PTO shaft speeds of various
implements, see the implement Operator's Manual.
A Whenever the PTO speed is changed to the other
speed, it is necessary to switch the PTO speed display
mode of the side digital display. Otherwise the PTO
speed will not get correctly displayed in the side digital
display. (See "SIDE DIGITAL DISPLAY" in
"OPERATING THE TRACTOR" section.)
PTO 540 / 540E rpm model (if equipped)
(1) PTO gear shift lever (A) 540 rpm
(N) "NEUTRAL POSITION"
(B) 540E rpm
Shiftable PTO (540 / 1000 rpm) model (if equipped)
(1) PTO shaft
(2) Snap ring
(A) 540 rpm PTO shaft
(B) 1000 rpm PTO shaft
To Next Page
Loading...
