3-POINT HITCH & DRAWBAR82
C Detaching Implement from Tractor
1. Fully lower the implement to the ground.
Support the implement with parking stand. (if
equipped) If necessary, adjust the top link and or lifting
rod length so that the implement may stabilize on the
ground.
2. Pull the release lever on the top link to release the
hook from implement ball-joint.
Hook the top link in the top link support.
3. Pull the release lever on both lower links to the
unlocked position to release the quick hitches from
implement ball-joints.
The latches will disengage and allow the lower links to
lower and detaching the implement.
DRAWBAR
To avoid personal injury or death:
A Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward causing
personal injury or death.
A The drawbar load is referred to "IMPLEMENT
LIMITATIONS" section.
(1) Top link
(2) Lower link
(3) Latch
(4) Release lever
(A) "LOCK" position
(B) "UNLOCK" position
Type: A (hitch made by V.ORLANDI)
To Next Page
Loading...
