GENERAL
RTV1140CPX, WSM
G-24
Checking Tire
1. Check to see if tires are not damaged.
2. If the tires are cracked, bulged, or cut, or they are worn out,
replace or repair them at once.
Tire Tread Depth
Always replace the tires when the tread depth is worn to
minimum depth.
9Y1210293GEG0030US0
[3] CHECK POINTS OF EVERY 50 HOURS
Checking Engine Start System
To avoid personal injury:
• Do not allow anyone near the vehicle while testing.
• If the vehicle does not pass the test, do not operate the
vehicle.
Preparation before testing
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
Test: Range gear shift lever safety switch
1. Sit on the operator's seat.
2. Shift the range gear shift lever to "H", "M", "L" or "REVERSE"
position.
3. Return the speed control pedal to the "NEUTRAL" position.
4. Shift the hydraulic lift cylinder lever to the "NEUTRAL" position.
5. Turn the key to "START" position.
6. The engine must not crank.
7. If it cranks, adjust or replace the required safety switch.
9Y1210293GEG0031US0
A: 3 mm (0.12 in.)
(1) Range Gear Shift Lever
(2) Hydraulic Lift Cylinder Lever
(3) Speed Control Pedal
To Next Page
Loading...
Need help?
General
