Why my KUHN Lawn Mower is producing badly shaped windrows?
If your KUHN Lawn Mower is producing badly shaped windrows, several factors could be responsible. First, check the PTO speed (rotational frequency) against the decal fitted on the machine. If the rotor speed is too high, select the turtle position to obtain a rotor speed of 780 min-1. Finally, ensure that both swath shields are correctly adjusted.
What to do if soil build up in front of the cutterbar of KUHN 4060TCD?
If soil is building up in front of the cutterbar of your KUHN Lawn Mower, it could be due to too much cutterbar down pressure. Try adjusting the mowing unit ground pressure to reduce this. Also, very wet working conditions can contribute to this issue, so adjust both the mowing unit ground pressure and the cutting height.
How to fix uneven stubble with KUHN 4060TCD Lawn Mower?
If your KUHN Lawn Mower leaves uneven stubble, several factors could be the cause. The knives might be dull or broken, in which case you should replace them. Also, ensure the knives are installed correctly with the arrow on the knife's upper face pointing in the disc's direction of rotation. Excessive ground speed, incorrect cutting height, or incorrect mowing unit floatation can also lead to this issue; reduce ground speed, adjust the cutting height, or adjust the mowing unit ground pressure accordingly. If you're dealing with tangled and down crops, try reducing the cutting height and increasing the mowing unit ground pressure.
Why is my KUHN 4060TCD Lawn Mower rotor finger rattling?
If your KUHN Lawn Mower's rotor fingers are rattling, it could be due to insufficient rotor speed. To resolve this, select the rabbit position to achieve a rotor speed of 1000 min-1. Another possible cause is that the conditioning hood is too closed; try positioning the rotor conditioning hood further away. Excessive ground speed can also contribute to this issue, so reducing your ground speed may help.
What to do if conditioning rotor of KUHN Lawn Mower is obstructed?
If the conditioning rotor of your KUHN Lawn Mower is obstructed, it could be due to several reasons. The rotor speed (rotational frequency) might be insufficient; try adjusting the finger conditioning rotor speed. Also, check the PTO speed (rotational frequency) against the decal on the machine. Finally, make sure the swath shields are not too closed; open them up to allow for better flow.
Why KUHN Lawn Mower requires too much pull power?
If your KUHN Lawn Mower requires too much pull power, it might be due to excessive cutterbar down pressure. Adjust the mowing unit ground pressure to alleviate this issue.
Explains safety symbols and emphasizes reading all safety instructions and warnings.
Covers safety decals, operations, coupling, manoeuvres, and machine use precautions.
Safety guidelines for PTO shafts, hydraulic circuits, and remote controlled components.
Precautions for driving, road transport, speed limits, and road safety equipment.
Safety checks before use, tyre safety, and precautions during maintenance/repair.
Detailed instructions for correctly installing and adjusting primary and intermediate PTO shafts.
Procedures for adjusting cutting height and ground pressure.
Adjusting finger conditioning rotor speed and conditioning intensity.
Operation and adjustment of swath shields and wide spreading fins.
Procedures for lubricating PTO shafts, universal joints, and greasing points.
Steps for draining and refilling oil in cutterbars and gearboxes.
Inspection and replacement of knives, bolts, nuts, and spring plates.
Maintenance of rotor fingers and replacement of shear bolts/nuts.
General| Brand | KUHN |
|---|---|
| Model | 4060TCD |
| Category | Lawn Mower |
| Language | English |
To Next Page
