KUHN FC313 RF - Road Regulatory Compliance

Mower conditioner
34
FC313 RF
Putting into service
 Fitting the rear protection cover
- Close and lock machine swath shields.
- Before attaching tensioner end (1) to the swath shield,
slide it underneath the latch.
- Hook tensioner end (2) to the safety chain.
 Uncoupling the machine
From the transport position:
- Lower the transport lock lever in working position (1).
- Lift the machine with the tractor's three point linkage.
- Release and lower parking stands (2).
- Release and lower lateral parking stand (3).
- Remove check chains on tractor side.
- Uncouple the PTO shaft from the tractor.
- Remove "A" frame coupler lock pin.
- Disconnect and store electric plug in its holder.
- Lift the mowing unit using the machine's lift cylinders
to release transport locks.
- Lower the mowing unit using the machine lift
cylinders.
- Lower the tractor three-point linkage to rest the
machine on the ground.
- Remove the tensioner from the rear swath shield
cover.
- Open machine swath shields to avoid interferences
with the tractor's "A" frame coupler.
- Disconnect and place hydraulic hose coupler in its
support.
- Lower the tractor's front linkage and uncouple the "A"
frame coupler.
The machine is uncoupled.
2
1
1
2
3