Why is my KUHN GMD800GII-FF leaving uneven stubble?
Uneven stubble can occur due to several reasons: * Dull or broken knives: Replace the knives. * Incorrectly installed knives: Ensure the arrow on the knife's upper face points in the disc's rotation direction. * Insufficient disc speed: Check the belt tension. * Low PTO speed: Increase the speed to 540 min-1. * Cutter bar pitch angle too high: Reduce the angle.
What to do if KUHN GMD800GII-FF has bad ground contour adaptation?
If your KUHN Farm Equipment isn't adapting well to ground contours, consider the following: * Incorrect main frame setting: Adjust the main frame height with regards to the ground. * Excessive ground speed: Reduce ground speed. * Hydraulic cylinder blocked: Set the hydraulic valve in floating position. * Incorrect compensating spring adjustment: Adjust the compensating spring tension. * Worn or seized cutter bar pivot bushes: Check the condition of pivot bushes and replace them if necessary.
What to do if KUHN GMD800GII-FF stubble is too long?
If the stubble is too long when using KUHN Farm Equipment, it could be due to: * Incorrect cutter bar pitch angle: Modify the pitch angle using the top link. * Machine too light: Adjust the compensating spring tension and check the frame position.
Why is soil building up in front of the cutterbar of my KUHN GMD800GII-FF Farm Equipment?
Soil buildup in front of the cutterbar on your KUHN Farm Equipment can be caused by: * Too much cutterbar down pressure: Adjust the compensating spring tension. * Very wet working conditions: Adjust the main frame height with regards to the ground and fit raised skid shoes.
Why does KUHN GMD800GII-FF Farm Equipment have too frequent safety breakback release?
If the safety breakback releases too frequently on your KUHN Farm Equipment, it may be due to insufficient spring washer compression. Increase the spring washer compression to resolve this issue.
What to do if there is interference between tractor and front guard of KUHN GMD800GII-FF Farm Equipment?
If you're experiencing interference between the tractor and the front guard of your KUHN Farm Equipment, the incorrect cam adjustment may be the reason. Adjust the machine pivot moment to correct this.
What to do if incorrect mowing unit positioning with regards to the tractor when placed in working position of KUHN GMD800GII-FF?
If the mowing unit positioning is incorrect with regards to the tractor when placed in working position of your KUHN Farm Equipment, use the tractor double acting position to lower the mowing unit, as the tractor valve double acting position has not been used to lower the mowing unit.
General safety guidelines for operation, maintenance, and repair.
Identifies and explains the purpose of safety warning decals.
Lists key technical data and dimensions of the machine.
Step-by-step guide for attaching and detaching the machine to a tractor.
Procedures for converting the machine for transport.
Guidelines for safe and legal road operation.
Procedures for converting the machine for operation.
Details on setting up the machine for optimal cutting performance.
Guidance on operating the machine during mowing operations.
General| Brand | KUHN |
|---|---|
| Model | GMD800GII-FF |
| Category | Farm Equipment |
| Language | English |
To Next Page
