6. Unscrew the 2 screw on the handle , fix on the opposite side of the door. Remove the screw on the right
fix piece, fix the left fix piece(from
accessory bag) to the door.
7. Remove the right bottom hinge by removing the 3 screws, than fix the 3 screw back without hinge .
8. Remove the hinge pin on the right bottom hinge and reinstall on the left bottom hinge.
9. Remove the 3 screws from the left side and fix the left bottom hinge on the unit.
10. Place the door on the left bottom hinge. With
the magnetic gasket holding the door in place, make sure
the door is aligned with the unit, and secure the top hinge on the left with 2 screws.
11. Open and close both the door several times to confirm the door is positioned correctly and the gasket is
sealed well. If this is not the case, please adjust the door again.
12. Fix the Fix plate back on the right side. Fix the top cover with 2 screw, cover the screw hole with the
Screw hole cover.
13. Wait at least 30 minutes before plugging in t
he refrigerator to allow the
refrigerant to settle down. Then plug in the unit.
Right bottom
Hinge
hinge pin
Handle
Left fix
piece
Right fix
piece
Handle
Move
Change
Left bottom
hinge
Hinge pin
Top
Hinge
Fix plate
Top cover
Screw hole cover
Unit top surface
To Next Page
