OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1.
Remove the exterior and interior packaging. Check if all the accessories, including instruction
manual, ice scoop, white water inlet pipe, 4 ways to 2 ways water quick connector and the water
draining pipe, etc., are inside or not. If any parts are missing, please contact our customerservice.
2.
Remove the tapes for fixing the door and inner cabinet, ice scoop, etc.. Roughly clean the inner
cabinet & ice scoop with wet clothe.
3.
Put the ice maker on a level & flat floor, without direct sunlight and other sources of heat (i.e.: stove,
furnace, radiator). Maker sure that there is at least 50cm gap between the air outlet and the
obstacles, and at least 5 cm between the wall.
4.
Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in if the unit maybe fall
upside down during shipping or transportation.
5.
The appliance must be positioned so that the plug is accessible.
WARNING: connect to the potable water supplying only. Only use drinking water.
DOOR REVERSING (Optional)
If you want the refrigerator door to open from the opposite side, you can reverse the door swing.
1. Ensure the unit is unplugged before starting door reversal.
2. Remove the 2
Screw hole cover on the top cover,unscrew two screw which is fix the top cover.
3. Remove the 2 screws from the top hinge, and 2 screws from the fix plate.
4. Lift the door up and take off the door.
5. Set the freezer door on a non-scratching
surface with the outside up.
Handle
Handle
Right
bottom
Hinge
Right fix
piece
Q
Left fix
piece
Left
bottom
hinge
Top
Hinge
Top
Hinge
Fix plate
Top cover
To Next Page
