INSTALL ATION LOCATION REQUIREMENT
a)
This unit is not for outdoor use. Keep the proper room temperature and inlet water
temperatur e according to above specification table. Otherwise it will af fect the ice making
performance.
b)
This unit should not be located near any heat resource.
c)
The unit should be located on a firm & level foundation at normal cou nter top heig ht.
d)
There must be at least 5CM clearance at rear side for connection and 25 CM clearance in
front to open the d
oor and keep good air circulation.
e)
Do not put anything on the top of the ice maker.
Installation clearance
top view (mm) Side view (mm)
5
[0.2]
50
[2.0]
5
[0.2]
5
[0.2
]
50
[
2
.0]
To ensure proper ventilation for your ic e maker, the front of the unit must be c ompletely unobstructed (at
least 40CM free space). Allow about 5 mm clearance at rear, and 5 mm at top f or proper air circulatio n.
The installation should allow the ice maker to be pulled forward for servicing if necessary.
When installing the ice maker under a counter, follow the recommended spacing dimensions shown
above. Place electrical and water supplies and drain fixtures in the recommende
d locations as shown.
Choose a well-ventilated area with temperatures above 50 Fahrenheit and below 90Fahrenheit. This unit
MUST be installed in an area protected from the elements, such as wind, rain, water spray or dri ps. The
ice maker requires a continuous water supply with pressure 1-8 Bar as required in above specif ic ati on
table. The temperature of the water feeding into the ice maker should be between 41Fahrenheit and
77Fahrenheit for proper operation.
To Next Page
