DO NOT use solent cleaning agents or abrasives on the interior.
These cleaners may transmit taste to the ice cubes,or damage
or discolor the interior.
1.
Disconnect power to the unit.
2.
Open the door and with a clean cloth, wipe down the interior with a sanitizing solution made of
28g of household bleach or chlorine and 7.5L of hot water(95℉ to 115℉) .
3.
Rinse thoroughly with clear water. The waste water will be drained out through the drain pipe.
4.
Reconnect power to the unit.
The ice scoop should be washed regularly. Wash it just like any other food container.
Ice Making Parts Cleaning
During the using, periodically to clean these main system of your ice-maker.
1、Repeat above step to clean the water tank and
other inner parts of the unit.
2、Especially, to the water dividing pipe on the
evaporator, when the compressor and the water
pump run normally, but if there is no water
flowing out from the water dividing pipe or the
water flowing is very small, please discharge
this water dividing pipe to clean carefully. Clean
each little holes on the water dividing pipe
displayed in the following illustration, make sure
each hole is not clogged by something, then
install back to the original location.
3、 When there are ice cubes on the surface of the evaporator, but can’t fall down easily, do not use the
mechanical substance to remove it by force; Only press the “ON/OFF” button for more than 5
seconds, the unit will enter the ice melting process, after some while, the big ice-cubes will fall
down, then turn off the unit and unplug the power cord to clean the surface of the evaporator.
4.
For the water tank and ice-full detecting plate
Also the water tank and the ice-full detecting plate is very
important to keep your ice cube hygienic. Put mixture of
neutral cleaner & water into a clean water jet, then spray to
all the inner surface of tank & the ice detecting plate. Wipe
these surfaces as far as possible with a clean cloth. And
then, spray the surfaces with clean water, wiping with a dry
clean cloth. Then drain out the cleaned water in the water
tank by pulling out the Water drain pipe of the water tank
indicating “H” in above illustration. When all of the cleaned
water has been drained out, to reinstall back the water drain
pipe of the water tank.
To Next Page
