Operation button and display area diagram
Operation the ice-making process
1.
Starting up
：
Plug in the power plug,the symbol will flash in the display window,press the
ON/OFF button on the control panel,the machine will start to make ice when the external pipe add
water to reach the standard level on the water tank through the electromagnetic water valve,then
the symbol will change to light on always in display window and symbol rotate;The
ambient temperature will be displayed in the upper left of the display window，“80F”means the
ambient temperature is 80F,several minutes later,the flashing numbers will be displayed in the
ambient temperature display area,the flashing number“10M”means still need 10minutes to finish
this ice making cycle.
2. Every ice making cycle finished,enter deicing process,the symbol flash
，
the external pipe can
add water to the water tank through the electromagnetic valve,and the arrow on the symbol
will flash until the water reach the standard level,then the symbol extinguish，the unit enter
the next ice making cycle；When the water can not reach the standard level,the symbol is
always bright,the unit stop working.After water shortage,the unit needs to be restarted,otherwise it
will start up automatically after 15 minutes.
Note ： Each ice making cycle is around 11-20minutes,the ice making time will be changed
according to the ambient temperature and the water temperature change.Especially the first
ice making cycle,the ice making cycle will be longer because of the high water temperature
in the water tank,.But the cie making cycle will not over 30minutes.
3. Adjust the ice thickness ;Press the
“
+
”、“－”
button on the control panel to adjust the ice thickness
；
The number in the bottom left of the display window is the setting of the ice making time, default is
“0”,press“+”button one time the ice making time will add one minutes,the ice will be thicker；
Press “ － ” button one time the ice making time will reduce one minutes,the ice will be
thinner.Restart the machine it will go back to default“0”。
Note:The time currently set only changes the next and subsequent ice making cycle.
4.
When the symbol lights up，the machine stop working,it will work again after you take out
the ice.
5.
Shut down the unit：During the unit making ice，press the“ON/OFF”button on the control
panel，the unit shut down and into standby mode.If you press "ON/OFF" longer than 5S during ice
making, then the unit enters the deicing process directly, this function can help remove the ice on
To Next Page
