Kurzweil Artis SE - Using Artis SE; The Rear Panel; The DC Power Adapter

Introducing Artis SE
The Rear Panel
4
Using Artis SE
1. Power up the Artis SE, and then raise the MASTER VOLUME slider, and mixer/amp
volume. Your Artis SE keyboard starts up in Multi Mode by default. Press one of the
Mode buttons to the left of the display to switch Modes.
2. If you are connected to a mixing board and hear distortion, reduce the gain level on your
mixing board, or use the pad (a switch that decreases the input audio signal level, typically
by 20dB) if it has one.
3. Scroll through the Multis or Programs using the Alpha Wheel, the -/+ buttons, or press a
Category and Multi/Program button to audition the sounds in Artis SE.
The Rear Panel
e power switch and most of the Artis SE connections are located on the rear panel.
The DC Power Adapter
Use the provided DC power adapter to connect the Artis SE to a standard AC power source.
Please refer to Step 3 on page GS-4 above.