Kurzweil Artis SE - Connecting a Dual Switch Pedal

Introducing Artis SE
The Rear Panel
7
NOTE : It is not recommended to plug CC pedals into the SW
inputs. Due to the exible switch pedal support, CC pedals
may not operate as expected in these inputs.
Connecting a Dual Switch Pedal
You can connect a dual switch pedal with a single stereo plug, such as the Kurzweil KFP-2S,
into the SW1 Pedal and SW2 Pedal jacks. Both SW1 and SW2 can support a dual pedal each
allowing up to 4 pedals to be utilized by the Artis SE. ese are enumerated as SW1a, SW1b,
SW2a and SW2b. e Artis SE will recognize dual pedals that are wired as TS and RS, such
as the KFP-2S.
e default assignments for the Switch Pedals are summarized in the table on the following
page.