Disk Mode
Backup and Copy Functions
13-63
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Replace|or|increment|mode?||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Help||||||||||||||Replace|Increm|Cancel
Replace Any files to be transferred that already exist in the destination directory will be
replaced (overwritten.)
Increm Any files to be transferred that already exist in the destination directory will be
skipped (not transferred.)
Help Displays a reminder about the meaning of Replace and Increment modes.
After you select the Backup mode, you will see a confirmation screen with all of your selections
so far:
Press|OK|to|start|backup:SCSI|4->SCSI|0
Mode||=Replace|||||||||||||||||||||||||
Source=\|||||||||||||||||||||||||||||||
Dest||=\|||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||SetFile||OK|||Cancel
OK Begin the Backup function according to the parameters on this page.
Cancel Exit to Disk Mode.
SetFile Set Backup starting file. This is mainly used when you are backing up files from
a larger SCSI drive to several smaller removable media disks. Once one of the
removable destination media is full, note the last file that was successfully copied.
Enter the Backup function again, setting up the source and destination path
parameters exactly as before. But this time use the SetFile button to start from the
file after the last file copied.
You will notice that the file list displayed when SetFile is pressed is not in
alphabetical order, but in the actual order the files occur in the directory on the
disk:
Dir:\||||||||||||Sel:0/15||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||Set|start|file:ZYXWVUTS|.KRZ|||||418K|
|||||||||||||||||PLANKTON|||||(dir)|||||
|||||||||||||||||ANIMALS||.KRZ||||1097K|
|Total:9040K|||||VEGGIES||.KRZ||||2801K|
||||||||Root||Parent||Open|||OK|||Cancel
Find the last file copied from the previous partial backup. Set the list index to one entry past
the location of this file. If this file is already the last entry in the file list, the "next" file to
continue the multi-part backup would be the file or directory that comes after the file list entry
To Next Page
Loading...
Need help?
General
