15-14
Advanced KDFX
Effects Buses
Figure 15-7 Bus Overrides Engaged
If you now change the parameter value from inside the FX preset, it breaks the bus override. By 
doing this, however, you have changed the FX preset, and when you leave the FX preset you 
will be asked if you wish to save it. If you then save the FX preset, the bus mod will be 
permanently broken, but if you donÕt save the FX preset, it remains in its previous state, which 
means the bus mod remains intact.
Since bus overrides are part of the studio, they are not saved permanently until the studio is 
saved.
Changing the Bus Overrides
The default bus overrides that come up when you are working in a studio are often convenient, 
but you arenÕt required to use them as they are. You can assign any two of the FX presetÕs 
parameters to the bus overrides. (You cannot, however, assign both bus overrides to the same 
parameter.) When you save the studio, the parameters youÕve selected for the bus overrides on 
each FXBus are saved, along with their values.
If you set up a bus override and adjust a parameterÕs value, and then change your mind and 
assign a different parameter to that override, the value of the Þrst parameter (the one no longer 
assigned to a bus override) will revert to its original valueÑthat is, the value set inside the 
FX preset. This can be a helpful feature, in that it means you can use bus overrides as a 
ÒwindowÓ into an FX preset by scrolling through the various parameters. But keep in mind that 
you canÕt use this method to tweak parameters, because as soon as you move on, the parameter 
you tweaked gets Òuntweaked.Ó
EditStudio:FXBUS|PAU:3|Free:1||<>FXBus:1|
FX1||2||Big|Room|||||||||||Aux   ||Mix
Wet/Dry      :45%|||||Lvl:0ff   |Lvl:0.0dB
Out Gain     :1.0dB|||Bal:0%||||Bal:0%
Allocation:Auto
<more||INPUT||FXBUS||AUXFX||OUTPUT||more>
EditMultiFX:PARAM1|||||||||EffectSize:3/3
Algorithm:1|Panaural|Room
||||||||||||||||||||In|Gain|||:0.0dB
Wet/Dry|||:BusMod|||Out|Gain||:BusMod
Room|Size|:16.0m
Pre|Dly|||:4ms|||    Decay|Time:2.9s
HF|Damping:15804Hz
<more||PARAM1|PARAM2||||||||||||||||more>
Edit
Exit