15-18
Advanced KDFX
Output Section
Output Section
Figure 15-8 FXBuses and Physical Outputs
In the Output section, the various signal paths are routed to the K2600Õs physical outputs. Each
of the four output pairs, A, B, C, and D, has a selector switch to determine which signal it will
carry. All signals are stereo. The choices are:
Off No output.
PreFXn The signal coming into the FX preset on FXBus1, 2, 3, or 4. All of the EQs and
pan/width/balance settings of the input modules that are assigned to FXBusn are
active on this signal path, but the FX preset is not.
FXBusn The direct output, post-FX preset, from any of the four insert FXBuses.
Mix The signal from the Mix output, which can include the sum of any or all of the insert
FXBuses, and/or the Aux bus. The Level and Balance parameters on this page control
this output.
AuxFX The outputs of the Aux bus.
There are no restrictions on the settings. If you like, all four outputs can be carrying the same
signal: PreFX1, for example.
Aux
effect
Mixer
Pre FXBus1
FXBus1
Pre FXBus2
FXBus2
Pre FXBus3
FXBus3
Pre FXBus4
FXBus4
Aux
∑
Insert
FXBuses
Mix
Physical outputs
A
Output B
Output C
Output D
Off
Physical
Output A
To Next Page
Loading...
Need help?
General
