Kurzweil PC3K7 - The FX Pages: FX, AUXFX1, AUXFX2, and MASTFX; The Programmable Switch Pages: SWPRG1 to SWPRG8; The Utility Soft Buttons; Name

Setup Mode
The FX Pages: FX, AUXFX1, AUXFX2, and MASTFX
7-67
The FX Pages: FX, AUXFX1, AUXFX2, and MASTFX
ThefourSetupmodeFXpages—FX,AUXFX1,AUXFX2,andMASTFX—workthesamewayas
theEffectsmodepages—CHANFX,AUXFX1,AUXFX2,andMASTER.SeeChapter 9,Effectsfor
informationoneditingthesepages.YoucanusethenEffect(FXBypass)Modebuttontobypass
effectswhileediting.
The Programmable Switch Pages: SWPRG1 to SWPRG8
ThePC3K’seightProgrammableSwitchesaretheeightProgramSelectbuttonslocatedabove
theprogramCategorybuttons.EachbuttonhasitsownSWPRGpage,buteachpageis
essentiallyidentical.
TheSWPRGpageparametersaredescribedinSwitchControllerParameters on page 7‐31
The Utility Soft Buttons
InadditiontotheSetupEditor’spages,therearebasiclibraryand editingsoftbuttons.Their
functionsaredescribedbelow.
Name
Thisenablesyoutorenamethecurrentsetup.Useanydataentrymethodtodothis,including
thelettersonthealphanumericbuttonpad.
Save
PressingSavecallsupthestandardSaveDialog.SimultaneouslypressingthePlusandMinus
dataentrybuttonstogglesbetweensavingthesetuptothefirstavailableemptylocation,or
replacingacurrentlyexistingsetu p.Formoredetailedinstructionsonsaving,seeSavingand
Naming on page 5‐3.
Parameter Range of Values Default
Type Momentary, Toggled Toggled
On Control Control Destination List OFF
On Value None, 0 to 127 None
Off Control Control Destination List OFF
Off Value None, 0 to 127 None
Entry Value None, Off, On None
Exit Value None, Off, On None