Kurzweil PC3K7 - Opaque; Sustain Pedal (Suspdl); Sostenuto Pedal (Sospdl); Freeze Pedal (Frzpdl)

Program Mode
The LAYER Page
6-25
Repeatthisforeachlayerintheprogram.Bearinmindthatifyouwanttosetup32different
velocitylevelsforaprogram,withequalintervalsbetweeneachlayer,thenyouhavearangeof
4foreachlevel(Layer1is0–3,Layer2is4–7,andso
on).Itwon’tbe easytoplayprecisely
enoughtotriggerthelayeryouwant.Ontheotherhand,ifyou’reusingSongmodeoran
externalsequencer,youcaneditattackvelocitylevels,andgetexactlytheresultsyouwant.
Opaque
Anopaquelayerblocksallhigher‐numberedlayersinitsrange,allowingonlytheopaquelayer
toplay.Thisisaneasywaytochangeasmallrangeofnotesinaprogram,leavingtheoriginal
soundplayingaboveandbelowthenewsound.
Startwithaone‐layerprogram,and
createanewlayer(Layer2)withtheNewLyrsoftbutton.
OntheKEYMAPpageforLayer2,selectthekeymapyouwanttouse,thenontheLAYERpage,
setLayer2’srange(say,C3toD3),andsetitsOpaqueparametertoOn.Thengoto
Layer 1,and
duplicateit(withtheDupLyrsoftbutton);theduplicatelayerbecomesLayer 3.Younowhavea
three‐layerprogram.DeleteLayer1(theoriginallayer);Layer2(thenewlayeryoucreated)
becomesLayer1,andLayer 3becomesLayer 2.NowLayer 2blocksoutLayer 3(theduplicate
oftheoriginal
layer)atthenotesC 3–D 3.
Sustain Pedal (SusPdl)
Whenthisparameterison,thelayerwillrespondtoallsustainmessages(Controllerdestination
64,Sustain).Whenoff,thecurrentlayerwillignoresustainmessages.On2meansthatthe
sustainpedalwillnotcatchthereleaseofanotethatisstillsoundingwhenthesustainmessage
isreceived;this
canbeveryusefulinaprogramthatusesamplitudeenvelopeswithalong
releasetime.
Sostenuto Pedal (SosPdl)
WhenSostenutoison,thelayerwillrespondtoallsostenutomessages(Controllerdestination
66,Sostenuto).Whenoff,thelayerignoressostenutomessages.Sostenuto,asyoumayknow,isa
featurefoundonpianosthathavethreepedals.PressingtheSostenutopedalonapiano(usually
themiddlepedal)sustainsthe
noteswhosekeysyouwereholdingdownwhenyoupressedthe
pedal.Notesplayedafterthepedalisalreadydowndonotgetsustained.
Freeze Pedal (FrzPdl)
Thisparameteractivatesordeactivatesthelayer’sresponsetoFreezepedalmessages
(Controllerdestination69,Freeze).TheFreezepedalcontrolcausesallnotesthatareonto
sustainwithoutdecayuntiltheFreezepedalcontrolgoesoff.Ifanoteisalreadydecaying,itwill
freezeatthatlevel.
Ignore Release (IgnRel)
Whenon,thelayerwillignoreallNoteOffmessagesreceivedbythePC3K.Thisshouldbeused
onlywithsoundsthatdecaynaturally,otherwisethesoundswillsustainforever.WhenIgnRelis
off,thelayerrespondsnormallytoNoteOffmessages.Thisparametercancomeinhandywhen
yourPC3K
isslavedtoadrummachineorsequencer,whichsometimesgeneratesNoteOnsand
NoteOffssoclosetogetherthattheenvelopedoesn’thavetimetoplaybeforethenoteis
released.You’llalsowantto usethisparameterwhenyou’ replayingstaccato,andthesound
you’replayinghasa
longamplitudeenvelope.Thisparametershouldbeusedonlywithnotes
thateventuallydecaytosilence.Sustainingsoundswillsustainforever.
DonotuseIgnoreReleasewithMonophonicprograms(page 6‐34).