18
TracPhone V30 Installation Guide
Turn On the System
Turn On the System
Follow these steps to turn on the system.
1. Ensure the antenna has a clear, unobstructed view of
the sky.
2. Apply vessel power to the TracPhone V30 system.
3. Press the power button on the back of the VSAT-Hub.
The button’s light should illuminate blue.
Figure 25: Power Button
4. Within a minute, the “VSAT-Hub” light will glow green.
Within a few minutes, the “Antenna” light will be
flashing green, indicating the antenna is searching for
the satellite.
Figure 26: Status Lights
IMPORTANT!
During startup, the VSAT-Hub checks the software
versions installed in the antenna and updates them if
necessary to match the versions it has stored for the
model. All three status lights will alternate orange while
this update is in progress. Do not turn off the system
during this time. Updates might take up to 30 minutes.
To Next Page
Loading...
Need help?
General