TracVision TV5 User’s Guide
23
Network Settings
Resetting Network Settings to Factory Defaults
If the TV-Hub’s network configuration becomes corrupted such that
you can no longer access the web interface, you can reset all of the
network settings to their original factory settings.
To reset the network settings to factory defaults, use a paper clip or
pencil to press and hold the Reset button on the rear panel of the
TV-Hub. Hold the button for about 5 seconds then release. The
TV-Hub will reboot.
Figure 3-6 Reset Button (TV-Hub A shown)
Important!
Resetting the system will turn off wireless security and clear your
password. Be sure to reapply security settings to prevent unauthorized
access. See “TV-Hub Wireless Settings” on page 21 for details.
To Next Page
Loading...
Need help?
General
