TracVision TV5 User’s Guide
77
Switching Satellites
Selecting the Master Receiver
The master receiver controls satellite selection. The TracVision antenna
will switch between satellites automatically as you change channels
using the master receiver’s remote control. All other receivers will
only be able to select channels that are carried by the currently selected
satellite.
NOTE: The system must first be set to Automatic satellite switching mode
before you can select a master receiver. See “Selecting Automatic Switching
Mode” on page 76.
To make a different receiver the master, simply select it on the Home
page of the web interface.
Figure 7-9 Master Receiver Selection
As an alternative, if the receiver is connected to an IP AutoSwitch, you
can press the Master Select button on the IP AutoSwitch to make its
associated receiver the master.
Figure 7-10 IP AutoSwitch Master Select Button
To Next Page
Loading...
Need help?
General
