TracVision TV5 User’s Guide
46
Receiver Settings
6. When the number for your remote control appears on the
screen, select Continue.
7. Wait while the receiver downloads the latest software. This
update may take up to 20 minutes.
8. At the Set Video Resolution screen, select the highest video
resolution that is supported by your TV. Then run the
resolution test and save your setting.
9. Allow the receiver to run two tests of its landline connections
(Ethernet and phone). It probably won’t detect any, since the
receiver is installed in a mobile environment.
10. At the Activate Receiver screen, press STAR (*) on the
receiver’s remote.
11. At the Setup Details screen, select Point Dish. Then select
Check Switch. The receiver now runs the Check Switch test.
12. At the Installation Summary screen, make sure all of the
satellites you installed in the TracVision antenna are listed
“OK.” Also be sure the switch type is “DP34.” If you do not see
these results, select Test to run another test. Otherwise, select
Done.
Figure 5-7 Check Switch Test Results
13. At the Point Dish screen, select Done.
To Next Page
Loading...
Need help?
General
