Kwikset 62873/01 - User Manual

62873 / 01
Door edge NOT
chiseled
A
A
B
C (2x)
or
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 3.
If the latch holes are NOT centered, adjust
latch. See “Latch Adjustment” (step 2C).
M*
A
F
K
L
H
J
B
C
D
E
Adapter*
*Adapter only
included with
straight levers
Parts in the boxRequired tools
Latch StrikeScrews
Keys
Levers
Not required for all
applications
Allen wrench
wood block
Additional tools
(if needed)
Installation Guide
*Call Kwikset to order
a service kit for 21/4"
(57 mm) thick doors.
23/8" (60 mm)
or
23/4" (70 mm)
13/8"–21/4"*
35 mm–57 mm*
21/8"
54 mm
1"
25 mm
Hold the latch in front of the door hole, with
the latch face lush against the door edge.
Latch Adjustment (only if needed)
Move the pin to
extend the latch.
not centered
centered
23/8" (60 mm)
23/4" (70 mm)
Backset
Centerline
13/8" (35 mm)
13/4" (44 mm)
21/4" (57 mm)
Edge of the door
Fold
Drilling Template
Instructions continue on reverse
Template is only needed if a new hole must be drilled in the door.
Face of the door
Door edge chiseled
wood block
slant of latch bolt faces door frame
slant of latch bolt faces door frame
door frame
door frame
Remove plates.
Install drive-in
collar.
A
A
B
C
Prepare door and check dimensions
1
Adjust the backset of the latch (if needed)
2
Install latch
3

Kwikset 62873/01 Specifications