CONTROLS & FEATURES
USB Charging Meter: Plug electronic device in,
the indicator will be ON when it is charging, it will
be OFF when it is not charging. It will flash when
the battery voltage is too low. The circuit will be cut
off if the electric current is over-load to protect
your device.
Battery Voltage and Digital Clock
Adjust clock
1. Turn the ignition switch to the ON position.
2. Push the MODE button to toggle between ODO
, trip and oil service and choose ODO mode.
3. Push both MODE and ADJ for more than 2
seconds. The “hour” digits will begin flashing,
you can adjust it by pressing ADJ button.
4. Push the MODE button, the minute digits will
begin flashing, you can adjust it by pressing
ADJ button.
5. Push both the MODE and ADJ at the same time
to finish the clock setting.
NOTE: The digital clock can be only adjusted in ODO
mode.
19
13
14
NOTE: The adjustment will be cancelled if any
button is not pressed within approximate
ten seconds.
NOTE: The clock will be reset to 12:00 when
the battery is disconnected.
13
14
To Next Page