7. Gently wash the air cleaner in clean, non-
flammable (high flash point) solvent such as
kerosene not gasoline. Allow the air cleaner
to dry throughly before applying oil. A wet air
cleaner will not fully absorb the oil.
─
8. Soak the air cleaner an equivalent (gear oil:
SAE 80 - 90) until saturated, then squeeze out
the excess oil.
9. Reassemble by reversing the disassembly
sequence.
POTENTIAL HAZARD
Using gasoline or low flash point solvents
for cleaning ATV parts.
WHAT CAN HAPPEN
A fire or explosion could result.
HOW TO AVOID THE HAZARD
Use only a nonflammable or high flash
point solvent to clean ATV parts.
WARNING
CAUTION:
Twisting the air cleaner when squeezing out
excess oil could damage the air cleaner.
The element should be wet but not dripping.
NOTE:
110
To Next Page
Loading...
Need help?
General
