If the engine fails to start, release the start
switch, then push the start switch again. Each
cranking should be as short as possible to
preserve battery energy. Do not crank the
engine more than 10 seconds on each attempt.
See the "engine break-in section prior to
operating engine for the first time.
7. If the engine is started with the starter
(choke) in position , the starter (choke)
should be returned to position to warm up
the engine. If the engine is started with the
starter (choke) in position , keep the starter
(choke) in this position to warm up the
engine.
8. Continue warming up the engine until it idles
smoothly and return the starter (choke) to
position before riding.
Starting a warm engine
Warming up
To start a warm engine, refer to the "Starting a
cold engine" section. The starter (choke) should
not be used. The throttle should be opened
slightly.
To get maximum engine life, always warm up the
engine before starting off. Never accelerate
hard with a cold engine! To see whether or not
the engine is warm, check if it responds to the
throttle normally with the starter (choke) turned
off.
46
NOTE:
CAUTION:
To Next Page
Loading...
Need help?
General
