POTENTIAL HAZARD
Removing the radiator cap when the engine
and radiator are still hot.
WHAT CAN HAPPEN
You could be burned by hot fluid and steam
blown out under pressure.
HOW TO AVOID THE HAZARD
Wait for the engine to cool before removing
the radiator cap. Always use a thick rag
over the cap. Allow any remaining pressure
to escape before completely removing the
cap.
Should be serviced by your authorized
KYMCO dealer when changing the coolant.
WARNING
Engine overheating
If your ATV overheat, wait until the engine has
cooled.
Check the coolant level in the reservoir tank
and/or radiator.
Restart the engine. If the engine overheats
again, ask a KYMCO dealer to inspect and/or
repair the cooling system
Level is low, check the cooling
system for leakage.
Ask a KYMCO
dealer to inspect
and repair the
cooling system.
Add coolant.
(See NOTE.)
Level is OK.
Leakage. No
If it is difficult to get the recommended coolant, tap water can be temporarily used, provided that it
is changed to the recommended coolant as soon as possible.
NOTE:
121
To Next Page
Loading...
Need help?
General
