Engine stop switch
Passing signal switch
When the switch is in the RUN ( ) position, the
engine will operate. When the switch is in OFF
( ) position, the engine will not operate.
This switch is intended primarily as a safety or
emergency control, and it should normally
remain in the RUN ( ) position.
When passing, if there are cars coming from the
opposite direction, press and release the
passing signal switch and the headlight will wink
to warn the coming vehicles.
If you stop your ATV by turning the engine stop
switch OFF ( ), be sure to turn the ignition
switch OFF to prevent battery discharge.
NOTE:
(1)
(2)
(1)Engine stop switch (2) Passing signal switch
21
To Next Page
Loading...
Need help?
General
