Turn the ignition switch is ON " " and make
sure the engine stop switch in the OFF " "
position.
Loosen the locknuts of rod.
Shift the gear to neutral by moving the shift
lever and/or turn the rod. (The neutral
．
indicator lamp comes on.)
Provide standard/phillips screwdriver (tool kit)
and pass the standard/phillips screwdriver
through the shift arm into the index hole at the
transmission case cover.
Turn the rod clockwise or counterclockwise
until the drive select lever into the "N" position
of the shift guide and tighten the locknuts,
then pull out the standard/phillips
screwdriver.
After adjustment, start the engine and test
ride the ATV to be sure the drive select lever is
operating properly. (See page 47~48.)
Drive select lever adjustment
1.
2.
3.
4.
5.
6.
34
(1) Locknuts
(2) Rod
(3) Standard/phillips
screwdriver (tool kit)
(4) Shift arm
(5) Index hole
(1)
(2)
(3)
(4)
(5)
To Next Page
Loading...
Need help?
General
