11-2
Troubleshooting > Indicators During Sending/Receiving Operation
Indicators During Sending/Receiving Operation
The [Processing] and [Memory] indicators show the fax transmission status.
•The [Processing] indicator blinks during fax transmission and reception.
•The [Memory] indicator blinks when source data is being stored in memory for memory transmission.
•The [Memory] indicator is lit when there is source data stored in the memory for delayed transmission.
Responding to an Attention Indicator Flashes
If the [Attention] indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message is not
indicated on the touch panel when the [Status/Job Cancel] key is pressed or the attention indicator flashes for 1.5
seconds, check the following.
Symptom Checkpoints Corrective Actions
Reference
Page
Cannot send fax. Is the modular cord connected
correctly?
Connect the modular cord correctly. —
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Check Permitted FAX No. and Permitted
ID No.
8-12
Has a communication error
occurred?
Check error codes in the TX/RX Result
Report and Activity Report. If the error
code starts with "U" or "E", perform the
corresponding procedure.
11-5
Is the destination FAX line busy? Send again. —
Does the destination FAX
machine respond?
Send again. —
Is there an error other than
above?
Contact your Service Representative. —
To Next Page
Loading...
Need help?
General
