Kyocera ECOSYS FS-6525MFP Technical Reference Manual

2-9
Drawing Circles
The CIR (draw circle) command draws a circle of a specified radius using the line thick-
ness set by the SPD (set pen diameter) command. The circle drawn is centered on the
current cursor position; the position of the cursor remains unaffected. See the following
example:
!R! RES;
UNIT C;
SPD 0.1;
MZP 8, 8;
CIR 1;
CIR 2;
CIR 3;
PAGE;
EXIT;
Figure 2. 7. Circles
Lines 1, 2 and 3 start PRESCRIBE mode, reset the printing system to its default parame-
ters, establish the unit of measurement as centimeters, and set the line width to 0.1 centi-
meters.
Next, the MZP command moves the cursor to the point that is 8 centimeters to the right
of the left edge limit and 8 centimeters below the top edge limit.
Lines 5, 6, and 7 draw three circles with radii of 1, 2, and 3 centimeters.
Drawing Filled Shapes
The standard graphics mode provides two types of filled shapes: arcs and blocks. Such
shapes are filled with one of the printing system’s predefined patterns, or with a user
defined pattern.
Filled areas of other shapes can be printed using path mode graphics. For details, see the
explanation in section Path Mode Graphics on page 16.

Kyocera ECOSYS FS-6525MFP Specifications

General

Type	Multifunction Printer
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Max Paper Size	A4
Duplex Printing	Yes
Connectivity	USB 2.0, Ethernet
Scanner Type	Flatbed with ADF
ADF Capacity	50 sheets
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Fax Transmission Speed	33.6 kbps
Print Speed	25 ppm
Copy Speed	25 cpm
Paper Capacity	250 sheets
Operating System Compatibility	Windows, Mac, Linux
Print Resolution	600 x 600 dpi