Kyocera ECOSYS MA4500ix - Sending Document Via E-Mail

5-18
Operation on the Machine > Sending Document via E-mail
Sending Document via E-mail
1
[Home] key > [Send]
2
Place the originals.
3
In the destination screen for sending, select [+] > [Email]
4
Enter destination E-mail address > [OK]
Up to 256 characters can be entered.
To enter multiple destinations, select [Next Destination] and enter the next destination. Up to 100 E-mail
addresses can be specified.
You can register the entered E-mail address in the Address Book by selecting [Add to Address Book]. You
can also replace the information for a previously registered destination.
Destinations can be changed later.
NOTE
• When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
Primary Network (Client) (page 8-55)
• Before sending a scanned document by e-mail, it is necessary to configure SMTP and e-mail sending from
Command Center
RX.
E-mail Settings (page 2-75)
Loading Originals (page 5-2)
Character Entry Method (page 11-10)
Confirmation Screen of Destinations (page 5-40)
NOTE
If [Prohibit] is set to “Broadcast”, multiple destinations cannot be entered.
Broadcast (page 8-29)